Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: DF 500 Materials  (Read 664 times)

0 Members and 1 Guest are viewing this topic.

Offline Musto

  • Posts: 12
DF 500 Materials
« on: September 29, 2018, 04:09 PM »

 Some one knows if the DF 500 can be used on "Trespa, Formica, HPL, phenolic plate"?
 

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Michael Kellough

  • Posts: 3535
Re: DF 500 Materials
« Reply #1 on: September 29, 2018, 06:16 PM »
Don't know the official answer but since the cutter tips are carbide I'd give it a try. Just experiment to find the right plunge speed (slower than for wood).

Offline Birdhunter

  • Posts: 2337
  • Woodworker, Sportsman, Retired
Re: DF 500 Materials
« Reply #2 on: September 29, 2018, 08:15 PM »
I’ve plunged into end grain Ipe so I think the 500 can cut almost any material. It’s wise to listen to the machine. If it sounds like it is laboring, slow the plunge. It’s also wise to let the cutter kiss the surface lightly at the beginning of the cut.to fast a start and you can snap off the cutter tip.
Birdhunter

Offline Festool USA

  • Festool USA Employee
    FOG Administrator
  • *
  • Posts: 8396
    • Festool USA
Re: DF 500 Materials
« Reply #3 on: October 01, 2018, 01:41 PM »
Yes, the DOMINO DF 500 can cut these materials. However, there are two caveats:

1. Speed - Slow feed rate to avoid chipping of the material and/or damaging of the cutter
2. Due to the material, expect shorter than normal cutter life - dulling will likely quicker than with wood materials

(Tyler)

Offline Oh Oh Domino

  • Posts: 2
Re: DF 500 Materials
« Reply #4 on: October 05, 2018, 03:03 PM »
Low and slow, baby.  Low and slow.
Domino 500 | TS 55 | Kapex 120 | OF 1400 | LR-32 | Extractors | Sanders | Drills | MFTs
Seeking Intervention for Serious Green Habit