Author Topic: 49"x98" cooktop table help  (Read 3198 times)

0 Members and 1 Guest are viewing this topic.

Offline sdcaprentry

  • Posts: 5
49"x98" cooktop table help
« on: April 21, 2018, 11:21 AM »
Hey Guys and Gals,

I have a project I am in the planning stages of for a good friend. He owns a teppanyaki table restaurant and needs new wood tables that the flat grill sits on. The flat top grill has a lip that overhangs the wood table on all 4 sides by 1 inch all the way around and can either sit flush or have a slight lip above the table. My initial thoughts were to use the domino xl and join to pre fab maple butcher block counter tops or do a large individual maple strips 1.25"x1.5". Which do you think would be fine?

I am leaning towards the two prefab counters because of the less planning needed after glue up, but not 100% set.

My second question is, any suggestions for a type of sealant or gasket to mate the two surfaces where the grill overhang sits?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.