Author Topic: Pluswood by Panolam  (Read 2079 times)

0 Members and 1 Guest are viewing this topic.

Offline Mark Kolkmann

  • Posts: 5
Pluswood by Panolam
« on: January 25, 2017, 02:27 PM »
Do any of you have any experience with Pluswood thermofused laminates by Panolam? Either good bad or ugly. I am looking into building some cabinets and have no experience with this product. I will be cutting it down with my TS55 and a laminate blade and want to make sure that I will not get too much chipping. I have read through quite a few threads on cutting laminate with the TS55 and would like to make sure this product will hold up. One of the building suppliers here in Minneapolis carries it.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline tjbnwi

  • Posts: 5517
  • Cedar Tucky Indiana
Re: Pluswood by Panolam
« Reply #1 on: January 25, 2017, 02:35 PM »
I've used Panolam, not that line. Their products I have used are excellent products. I use the TS 55 with the laminate blade.