Author Topic: FT: Systainer Foam Inserts and Three 5" sheets of Rubin 80 for RO125, etc.  (Read 2039 times)

0 Members and 1 Guest are viewing this topic.

Offline LaserGecko

  • Posts: 161
  • Tools Smarter Than Operator
Hi everyone,

I have two sets of Systainer Foam Inserts: two solid, one complete "Dice n Pluck", and one that's had a few pieces removed. I also have three sheets of Rubin 80 grit for the 5" rotary sanders.

I'd like to trade for some small neat thing (piece of wood or a sheet of veneer, an old router bit, that kind of thing), but will give them away for the cost of postage, too. They're not going to do me any good anytime soon, so I need 'em out of here.
« Last Edit: April 12, 2007, 02:57 PM by LaserGecko »
Jason Creager
Las Vegas, NV

This thread has been automatically locked meaning that forum members cannot reply to it. Please contact the seller via personal message (PM) or email to ask questions or coordinate a purchase. The seller may edit their original post or reply with additional details as needed. Sellers: please be courteous and mark the thread appropriately when your item(s) have sold.

Offline munchcolo

  • Posts: 26
  • Workshop Watchdogs
I don't have any veneer, but I do have some spare, used router bits.  PM sent.

Offline Programmergeek

  • Posts: 151
I can use the foam inserts you have for the systainers.  I also don't have any vineer but may have some router bits, what size shank do you need and any specific bit type?