Author Topic: 120V Sys Power Box  (Read 618 times)

0 Members and 1 Guest are viewing this topic.

Offline Dick Mahany

  • Posts: 122
120V Sys Power Box
« on: January 01, 2018, 01:46 PM »
Thanks to some inspiration found here on the FOG, I decided to build a US 120V power distribution box in a Systainer.  I just need to finish the inside rear cover panel and install a strain relief for the cord.  I used 12 gauge wire throughout and it was a little difficult to work in close quarters without distorting the systainer.  I was going to use a GFI, however all of the outlets that I typically use are already GFI protected. 

I'm only using this at home for my own personal use, so I'm not worried about OSHA or UL regulations. Just wish we could get a US version of the European power hub.  Any body listening at Festool?   [wink]

« Last Edit: January 03, 2018, 09:49 AM by Dick Mahany »

Offline TinyShop

  • Posts: 52
Re: 120V Sys Power Box
« Reply #1 on: January 08, 2018, 05:53 PM »
I agree. Anyone listening?

Nice work BTW! :)

Offline SRSemenza

  • Global Moderator
  • *
  • Posts: 8157
  • Finger Lakes Region, NY State , USA
Re: 120V Sys Power Box
« Reply #2 on: January 08, 2018, 07:46 PM »
Yeah, and pretty good combination in the CT-Sys stack. Makes sense.