Author Topic: Handle for SYS Cart  (Read 1888 times)

0 Members and 1 Guest are viewing this topic.

Offline peterstreit

  • Posts: 4
  • Festooladdict - but using all the tools i have
Handle for SYS Cart
« on: August 23, 2017, 06:51 AM »
I had problems with directing my Stack of Systainers while carrying something in the other hand.
So i used a SYS1 Systainer that i had laying around to build a Pushhandle with additional storage space.
let me tell you... it works well.
Enjoy  [smile]

Offline Vondawg

  • Posts: 160
Re: Handle for SYS Cart
« Reply #1 on: August 23, 2017, 07:17 AM »
Great idea there !
There are no mistakes....just new designs.

Offline GarryMartin

  • Posts: 1615
Re: Handle for SYS Cart
« Reply #2 on: August 23, 2017, 08:01 AM »
That's a great idea!  [not worthy]

I have four SYS-Carts and suffer from maneuverability problems some times so I think I will have to take a look at making one of those; might even see if I can find a good way of making it removable/re-positionable...  [scratch chin]

Offline Dick Mahany

  • Posts: 103
Re: Handle for SYS Cart
« Reply #3 on: August 23, 2017, 09:03 AM »
Very clever.  Nicely done !

Offline Gerald_D

  • Posts: 239
Re: Handle for SYS Cart
« Reply #4 on: August 23, 2017, 09:14 AM »
Excellent Idea! 

And  [welcome] to the FOG!

Regards,
Gerald
Gerald
I have Festools- Big and Small and a few other tools

Offline Gregor

  • Posts: 433
Re: Handle for SYS Cart
« Reply #5 on: August 23, 2017, 11:09 AM »
In case you don't want to glue something to your systainer: https://produktprogramm.tanos.de/index.asp?idart=365&idcat=22 might do the trick (minus the extra storage points).

Offline Svar

  • Posts: 1032
Re: Handle for SYS Cart
« Reply #6 on: August 23, 2017, 01:02 PM »
In case you don't want to glue something to your systainer: https://produktprogramm.tanos.de/index.asp?idart=365&idcat=22 might do the trick (minus the extra storage points).
Why not combine both concepts and make this removable perimeter handle:

Gray tabs go into four slots found on the front and sides of any systainer. Obviously round the corners and make cutout for the T-lock. One could do full perimeter, but that will require clearance for the opened lid when inserting the handle.
« Last Edit: August 23, 2017, 01:14 PM by Svar »

Offline ben_r_

  • Posts: 725
Re: Handle for SYS Cart
« Reply #7 on: August 27, 2017, 06:31 PM »
Not a bad idea! Thanks for sharing!
If at first you don't succeed, redefine success!