Author Topic: Removing Handle on Sys-toolbox2  (Read 610 times)

0 Members and 1 Guest are viewing this topic.

Offline UncleJoe

  • Posts: 114
Removing Handle on Sys-toolbox2
« on: April 09, 2017, 12:32 PM »
I am building some plywood storage/tool holders for my Sys-toolbox2 and it occurred to me that if I could just remove the handle I could build one piece that straddles the center hump and covers both sides and then replace the handle. It looks like it is just two tabs on each side but getting to them is the issue. Has anyone figured this out.
I am not young enough to know everything!