Woodworking & Power Tools Forum - Festool Owners Group > FESTOOL DISCUSSIONS > Festool How To... > Can't cut a circle with ps300 and circle cutter.
Pages: [1]   Go Down
« previous next »
  Print  
Author Topic: Can't cut a circle with ps300 and circle cutter.  (Read 1427 times)
0 Members and 1 Guest are viewing this topic.
Kingpen51

Offline Offline

Location: Lumberton, Texas
Member Since: Mar 2011
Posts: 14
« on: May 24, 2011, 09:47 AM »
I have the PS300 and the 490118 circle cutter and I can"t cut a good circle.  I'm using the scroll type blade 486563 and no progressive orbital mode.  I have to put the pin in the 200 hole to get close to a circle.  The 300 hole wants to go straight and sparks fly. Can someone please help.  A video would be great. Grin
Logged
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Qwas
Retailer

Offline Offline

Location: South GA
Member Since: Sep 2007
Posts: 572



WWW
« Reply #1 on: May 24, 2011, 11:16 AM »
It's been 4 years since I cut a circle with the setup you described so I may be a little rusty.  Smile I had problems at first too, then I studied up on the blade offerings. I tried a S75/4 FSG (486 551) which is designed for curving cuts and everything was fine.
Logged
Steve Adams  QwasProducts.com
Kingpen51

Offline Offline

Location: Lumberton, Texas
Member Since: Mar 2011
Posts: 14
« Reply #2 on: May 24, 2011, 03:03 PM »
I was using the recommended blade but It didn't work.  It makes since to use a Trion blade because the other problem is I cant get a 90 deg cut. Thanks for the reply.
Logged
wood pulp

Offline Offline

Location: Detroit, Michigan
Member Since: Feb 2010
Posts: 190


Each another's audience...
« Reply #3 on: May 25, 2011, 08:34 PM »
Sparks?  Are your guide blocks tensioned too tight?
Logged
Kingpen51

Offline Offline

Location: Lumberton, Texas
Member Since: Mar 2011
Posts: 14
« Reply #4 on: May 25, 2011, 11:27 PM »
Guide blocks seem to be OK.  The blade wants to flex away from center causing the sparks and not a 90 deg cut.  I got the pin in the correct hole using a Bosch blade.  It cuts a nice circle now but not a 90.  I am going to try and get a Trion blade next.
Logged
Pages: [1]   Go Up
  Print  
« previous next »
 
Jump to: