Author Topic: Client wants a round base  (Read 10491 times)

0 Members and 1 Guest are viewing this topic.

Offline CrazyLarry

  • Posts: 276
Re: Client wants a round base
« Reply #30 on: September 15, 2015, 02:01 PM »
I was just trying to assess whether @SMJoinery had become Americanised. We say Maths over here, not math  [smile]

It's worse than that, today I noticed that some don't even understand that sheet goods* is the singular there's no such thing as "sheet good"! (Even in amerikans as opposed to the Queen's English!!!)

*the culprit is cutlist bridge - sketchup -> cutlist fx software

Anyway back on topic(ish) @SMJoinery there's some great resources on the web now for solid geometry stuff

Fascinating comparing say with

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.