Author Topic: Conturo inlet roller-How to clean it  (Read 425 times)

0 Members and 1 Guest are viewing this topic.

Offline bawoodworks

  • Posts: 1
Conturo inlet roller-How to clean it
« on: October 18, 2018, 11:19 AM »
My inlet roller for my conturo is getting gummed up.  What is the best way to get at it and what to use to clean it.

Thanks,
Bruce

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline copcarcollector

  • Posts: 1436
Re: Conturo inlet roller-How to clean it
« Reply #1 on: October 18, 2018, 03:55 PM »
@Festool USA @TylerC

Perhaps FUSA has some tips and ideas....

Offline Festool USA

  • Festool USA Employee
    FOG Administrator
  • *
  • Posts: 8399
    • Festool USA
Re: Conturo inlet roller-How to clean it
« Reply #2 on: October 18, 2018, 04:36 PM »
We usually recommend using a non-harsh glue remover that can help in cleaning the rubber rollers. Using an adhesive remover that is harsh could damage the rubber and can deteriorate them.

(Tyler)

Offline tjbnwi

  • Posts: 5733
  • Cedar Tucky Indiana
Re: Conturo inlet roller-How to clean it
« Reply #3 on: October 18, 2018, 07:00 PM »
I just peel it off. It does not seem to stick well to the roller.

You may want to turn the glue feed down a little also.

Tom
« Last Edit: October 19, 2018, 06:30 PM by tjbnwi »