Author Topic: Cutting beyond mft capacity.  (Read 1114 times)

0 Members and 1 Guest are viewing this topic.

Offline Master Carpenter

  • Posts: 90
Cutting beyond mft capacity.
« on: May 24, 2018, 06:12 PM »
I needed to cut a stack of panels 60"x30". Not wanting to measure every one, I came up with the following.





I ripped the sheets with a non Festool parallel guide that has a larger capacity. A Kapex left side extension sets my 60" length, and switching out the 1080 rail for a 1400 gives enough cross cut capacity. Problem there is I lose the front key and my cuts go out of square. Solved by using the Festool parallel guide pulled very tight to sheet with a double check from a standard framing square. Once the cut is started, the blade in kerf stops the track from shifting.  Check after cut shows I'm within my tolerance on squareness.

The only other option I could come up with was to use dogs in the back holes of the mft and rail dogs for the crosscut. Anybody here have methods for cutting big pieces on an mft??


*excuse shop mess in background of picture, shops been super busy for a while and haven't had time to do a good between projects purge.
« Last Edit: May 24, 2018, 06:16 PM by Master Carpenter »
Ts 55, Ts 75, of 1010, lr 32, mft, mfs 700, RO 150 x2 + paper asort, RO 90 + paper asort, pro 5, df 500 + dom asort, hl 850 e, ti 15, t18, cxs, centrotec set, ct48, ct sys, vac sys, 32;55x2;118 tracks, a stack of sys and an og festool first aid kit. Kapex, planex, carvex, conturo.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Peter Parfitt

  • Magazine/Blog Author
  • *
  • Posts: 4039
    • New Brit Workshop on YouTube
Re: Cutting beyond mft capacity.
« Reply #1 on: May 25, 2018, 02:09 AM »
If one has a lot of larger sheets to cut then it may be worth while making up an impromptu tracksaw cutting station to suit the size of the largest cross cut. Forgive the blatant plug but this can be done in 15 to 20 minutes using the Parf Guide System. It is very accurate.

280059-0

280061-1

Peter