Author Topic: Do I need new collets? Can't insert bits into either 8mm or 1/4 for OF 1010  (Read 1720 times)

0 Members and 1 Guest are viewing this topic.

Offline mutterback

  • Posts: 3
Hi - During a prolonged move, I had my tools in storage for about a year. Now setting up my shop again, went to use my OF 1010 yesterday and I can't insert either 8mm or 1/4 bits into the collets. There was a bit of corrosion inside the nuts, which I believe I cleaned out fully. Reassembled... still won't fit.

Any tricks or tips, or should I just bite the bullet and buy 2 new collets?

Thank you!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline SRSemenza

  • Global Moderator
  • *
  • Posts: 8577
  • Finger Lakes Region, NY State , USA
Hi,

  Welcome to the forum!  [smile]

     How did you clean them?

   I suggest soaking in a cleaner to make sure all the nooks and crannies get thoroughly cleaned.

Seth

Offline mutterback

  • Posts: 3
Used a rust eraser, then a rag with 3 in 1 oil.

What kind of cleaner would you use? Would rather get a general purpose tool cleaner vs. router bit cleaner, as I don't use the router that often.

Offline Sparktrician

  • Posts: 3634
If the corrosion is in the bore of the collets, get .25 and .32 caliber rifle cleaning brushes, chuck them into your CXS, dunk them in Hoppe's No. 9, and have a go at the collets.  The brushes are bronze and won't hurt the collets.  Alternatively, a good soak in Naval Jelly might do the trick.   [smile]
« Last Edit: September 04, 2018, 07:58 AM by Sparktrician »
- Willy -

 "Remember, a chip on the shoulder is a sure sign of wood higher up." - Brigham Young

Offline mutterback

  • Posts: 3
Thank you! Will give it a try. There must be something inside the bore of the collets. I never had any trouble getting bits in previously....

Offline CADru

  • Posts: 50
Suspend them in a Extreme Simple Green aircraft and precision cleaner over night. Remove from solution rinse with water and blast them with compressed air. I have soaked carbide tipped blades with heavy pitch and resin, using this product, over night and the next day they sparkle new. No brushing needed.

https://simplegreen.com/industrial/products/extreme-aircraft-precision-cleaner/
CAUTION: All if any printing/paint on part of any kind may be removed by the solution.

Offline Cheese

  • Posts: 4953
I’d try 3M 800 Wet or Dry with light oil applied on a mandrel to lightly burnish the inside diameter of the collets. It probably won’t take much as everything is a close tolerance fit. Don’t reef on it just a simple kiss and a promise.  [big grin]
« Last Edit: September 05, 2018, 12:28 AM by Cheese »