Author Topic: Hose connections question  (Read 1116 times)

0 Members and 1 Guest are viewing this topic.

Offline bevans

  • Posts: 93
Hose connections question
« on: December 11, 2017, 10:52 AM »
I have connected a 27mm hose with a rotating connector and sleeve connector to work with a wall mounted boom arm in my shop. However, I can anticipate times when I want to disconnect the hose from the connector sleeve and clean up around the shop or even attachable tool to it. Is there a reducer for lack of a better term that will fit over the rotating connector end so I can fit my cleaning tools or sander? If there is can anyone provide the part number?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Corwin

  • Posts: 2611
Re: Hose connections question
« Reply #1 on: February 03, 2018, 09:40 PM »
Sorry for the late reply, but I just noticed this thread during a Search.

Anyway, the Suction Adapter D50/D36  (Item number 452897)  will work for some of what you want. This fitting's larger end fits over your hose's Rotating Connector. The fitting's small end has an outside diameter like that of the D27 hose's Hose Sleeve (tool end,) therefore, will fit into the same tools. However, the inside diameter is larger than that of the D27's tool-end fitting, so it will NOT fit the same tools that the D27 hose's tool end fits over.

So, the Suction Adapter fits inside the ends of your cleaning tools and tubes, and inside many other tools, like a TS55, for instance. It will also fit in the OF1400 router's ports, but not those on the smaller OF1010. And it won't fit on the sanders. 

Lastly, this is a non-antistatic fitting, if that makes a difference to you.
« Last Edit: February 03, 2018, 10:46 PM by Corwin »
Looks like your rabbit joint is a hare off! ;)