Author Topic: How Would You Solve This? (Panel Ready Dishwasher Needs Smaller Panel)  (Read 9929 times)

0 Members and 1 Guest are viewing this topic.

Offline Gregor

  • Posts: 411
I don't know how Gregor actually did it but I can envision a removable panel that sits on pins or small dominos (2 on each side) inserted into each adjacent panel the project out about a 1/2" and matching L-shaped or angled slots on each end of the removable filler piece. Then to install/remove you just lift it on/off no tools required. If it's an L-shaped slot then you line up the filler with the pins and push in then let it drop down to lock in place.

Put a slight back bevel on the top of the filler and a complementary bevel on the bottom of the door panel so to provide clearance for the door opening/closing.
I applied KISS and used a single L-shaped metal bracket (single line of screws) on each side. The IKEA panels I used have a real wood edgebanding so I was able to simply cut the top banding of the bottom filler into a triangle (and seal with clear coat) to make just enough room for the door to move - as it was my kitchen I could decide 'good enough'  ;).

More convoluted methods may need to be applied though in case the door moves down to much before swiveling inward.
It could be an option to use two brackets per side, the lower to form a rotation point for the filler (so it can turn outward on the top of it) by using one screw on the side of the bracket and add another bracked higher (just attached to the sides of the hole to form a stop so the filler will be perfectly vertical when closed), plus a rubber ring to pull the filler into the vertical closed position and some glide strip ontop of it to avoid scratching/friction. With this the door panel would be able to push the filler out a bit to make the room for itself to move.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline James Biddle

  • Posts: 79
These shelf pins can be used:

Instead of a horizontal shelf, it'd be a vertical one.

https://www.richelieu.com/us/en/category/furniture-equipment/furniture-shelf-pins/concealed-shelf-pin/shelf-pins-for-flipper-receptacle/1196389?s=shelf+pins

Those would be perfect...plus I have a Richelieu account.  Thanks.