Author Topic: MFT using 80/20  (Read 755 times)

0 Members and 1 Guest are viewing this topic.

Offline Green Koolaide

  • Posts: 108
MFT using 80/20
« on: January 15, 2018, 01:08 AM »
Has anyone built an MFT, any size, using 80/20?

I want one for workshop, does not meet to be portable but if could be foldable that would be good.

Has anyone done this? Would I risk cutting the aluminum extrusions if I used 3/4 MDF?

Sent from my SM-G935W8 using Tapatalk

"Five out of every four people have problems with fractions"

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.



Offline Michael Kellough

  • Posts: 3139
Re: MFT using 80/20
« Reply #2 on: January 15, 2018, 12:28 PM »
There have been a lot of threads on this topic but the search engine here is not so good.



Here is what google found using this string, "mft 8020 festool owners group"