Author Topic: Need help with door tenons  (Read 1646 times)

0 Members and 1 Guest are viewing this topic.

Offline Patman

  • Posts: 2
Need help with door tenons
« on: December 19, 2017, 04:25 PM »
What is the best way to do a bit bigger tenons that you have on for example doors?
.. The festool way, but not domino this time.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline jobsworth

  • Posts: 5235
  • Does Anyone Know What Time It Is?
Re: Need help with door tenons
« Reply #1 on: December 19, 2017, 06:41 PM »

Offline Rob-GB

  • Posts: 1078
Re: Need help with door tenons
« Reply #2 on: December 20, 2017, 12:17 AM »
These two posts may be of help
Making doors

and a pdf on mortise and tenons

Rob.
Problem? No such thing! Only a solution waiting to be found:- RJ

"A $2 guppy swims......" Deke

Offline JimD

  • Posts: 344
Re: Need help with door tenons
« Reply #3 on: December 24, 2017, 08:06 AM »
A lot depends on what tools you have and what sort of doors you need (or want).  I redid all our interior doors in a former home using construction lumber and shelf boards.  They were pretty simple four panel raised panel doors.  The early ones had a 1/4 groove all around the inside edges of the openings.  The panels were raised on both sides and went in them as did splines at the joints.  I added dowels at the joints and the doors worked.  Later I went to mortise and tenons and those doors were a bit more solid.  I raised the panels on my table saw but it can be done with router bits.  You could make simple doors like this with a planner, track saw, router, and drill. 

I've made mortise and tenon joints by drilling and chiseling (least favorite), plunge routering, and with a hollow chisel mortiser (currently most favorite, hoping for a domino some day).  I've used slip tenons and made traditional tenons.  For big pieces I like to put a dado blade on my radial arm saw and then trim with a shoulder plane.  I think the latter is the most important tool if you want to make normal tenons.  Too hard to cut to precise size, much easier to make a little oversize and trim to fit.