Author Topic: Planex LHS EX plus drywall sander  (Read 744 times)

0 Members and 1 Guest are viewing this topic.

Offline Grassant

  • Posts: 1
Planex LHS EX plus drywall sander
« on: February 10, 2018, 10:01 AM »
Just received this drywall sander. And wondering what pad and grit is best for skim coated drywall. And the same recommendations for popcorn ceiling removal.

I am a woman 5"6 140lbs. Strong for my size. What advise for what not to do. And any helpful to do advise.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline tjbnwi

  • Posts: 5894
  • Cedar Tucky Indiana
Re: Planex LHS EX plus drywall sander
« Reply #1 on: February 10, 2018, 10:31 AM »
If the skim was well applied, 180 or 220. If there are a lot of "bad" spots, you may need 150.

Use a couple of interface pads, extraction will be decrease slightly (I assume you got the CT 36 AC?).

120 on most popcorns, if it had never been painted try water and a scraper.

If you're going tp be doing a lot of skimming get these knives, thin the mud, roll it on, smooth;