Author Topic: Removing pore filler/finish with a rotex question  (Read 1164 times)

0 Members and 1 Guest are viewing this topic.

Offline zapdafish

  • Posts: 482
Removing pore filler/finish with a rotex question
« on: August 03, 2012, 11:55 AM »
What's the procedure and proper sandpaper for using a rotex to remove pore filler/finish?

I applied some pore filler to a coffee table top and didn't like how it changed the way the dye/stain looked so I used the Rotex to remove it. I had 80 grit granit on hand so used that. The paper gummed up real badly and every minute or so I'd stop and use my fingernails to remove the hardened whatever from the paper and start up again. I was in Rotex mode and had it on high speed.

When the sandpaper was clean it did an awesome job but I think heat caused it to start gumming up.


thanks
CT22, TS55, Kapex, RO150, Domino, RS 2 E

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.