Author Topic: RO150 FEQ  (Read 999 times)

0 Members and 1 Guest are viewing this topic.

Offline donduck2

  • Posts: 2
RO150 FEQ
« on: February 05, 2018, 01:28 PM »
Hi, New to forum, have owned several Festools over the years and I am still in awe of them. I am looking for advice on the RO150FEQ.  My sanding pad broke and I got a replacement but can not get the old one off.  I tried everything the directions said but no results.  Any advice?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Online GoingMyWay

  • Posts: 649
Re: RO150 FEQ
« Reply #1 on: February 05, 2018, 04:43 PM »
I also struggled a great deal trying to get the old one off.  You're probably already doing this, but make sure the sander is in aggressive mode so the pad locks.  I think I needed to push down hard on the pad while simultaneously turning as hard as I could to get the pad off.  It was really really hard for me to get it off and I was very winded after.  It doesn't help that I'm a relatively small guy - 5'5" with small hands so it was hard for me to really get a good grip on the pad.  I only changed the pad once (back in November 2017 so I don't remember exactly what I did) and pray that I don't have to do it again.  I believe it was a little bit easier to put the new pad on.

Hopefully a more experienced person can provide some better advice/assistance.
Inquiring Minds Want to Know

TS55, CT26, RO150, CXS, ETS 150/3, ETS EC 150/5, MFT/3, TS75, DF500, DTS400, OF1400, CT SYS

Offline rst

  • Posts: 2000
Re: RO150 FEQ
« Reply #2 on: February 05, 2018, 04:58 PM »
The pads are a bear to remove and install.  I just replaced mine and it was a struggle.  I lift at the Y and regularly install 100+ lb doors and install insulated glass units that also push that weight, I much prefer the ETS' with their screw attachment...my 12v impact makes that a piece of cake.  After I finally got the old one off, I almost took a file to the new one to install but grunted hard enough to get it on.  After that I took the new pad on/off a couple times hoping that will make it easier to change.
« Last Edit: February 05, 2018, 05:01 PM by rst »

Offline RobBob

  • Posts: 1322
Re: RO150 FEQ
« Reply #3 on: February 05, 2018, 07:21 PM »
A large strap wrench makes the job easy.

strap wrench