Author Topic: Sanding texture applied to sheetrock  (Read 1297 times)

0 Members and 1 Guest are viewing this topic.

Offline tduffy

  • Posts: 2
Sanding texture applied to sheetrock
« on: April 10, 2018, 01:30 PM »
I was wondering if anyone has had success sanding wall texture off of sheetrock with a sander? If so what grit would work the best? I am assuming a coarse 60 or 80 grit so it would not clog as much.
Any help would be appreciated.

Thank you, Tom

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Peter_C

  • Posts: 720
Re: Sanding texture applied to sheetrock
« Reply #1 on: April 10, 2018, 03:04 PM »
First wash the walls with TSP to remove contaminants, oils, etc. Rip it with 80 grit for a little bit, to rough it up, then skim coat it, with a really thin coating. Sand as needed, and repeat until desired level is reached. Sand as little as possible.

Offline tjbnwi

  • Posts: 5761
  • Cedar Tucky Indiana
Re: Sanding texture applied to sheetrock
« Reply #2 on: April 10, 2018, 03:57 PM »
Do as Peter describes.

Get a few of these knifes for laying down the mud.

https://www.tapetech.com/products/Premium-Finishing-Knives

Thin the mud, add No Pocks, roll on walls, lay out with above knives.

After a few passes you’ll get it laid down well enough where it will barley need sanding.

Tom

Offline tduffy

  • Posts: 2
Re: Sanding texture applied to sheetrock
« Reply #3 on: April 10, 2018, 04:19 PM »
Thanks guys..