Author Topic: Sandpaper recommendations  (Read 1679 times)

0 Members and 1 Guest are viewing this topic.

Offline jwjones2000

  • Posts: 11
Sandpaper recommendations
« on: March 28, 2018, 01:41 PM »
I need to clean up the fascia boards before painting.  I am planning on using my ROTEX 150.  What sandpaper type and grit do you recommend?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Sanderxpander

  • Posts: 193
Re: Sandpaper recommendations
« Reply #1 on: March 28, 2018, 03:13 PM »
I've used Granat for paint removal, I think it's recommended for that purpose too. Probably saves you a lot of paper if you scrape down the worst of it first. When I stripped my interior doors I used 40 for stripping in rotary mode, then 80, 120 and 180 to sand smooth again. You may not need to go up to 180 if it's relatively rough outside stuff.

Offline mwildt

  • Posts: 421
Re: Sandpaper recommendations
« Reply #2 on: March 28, 2018, 03:38 PM »
Search for 'air viper scraper' if you need a scraper. I do not have one yet but when the next scraping job presents it self that's what I'm going to try.