Author Topic: Sysport Drawer Shelf Template Or Dimension  (Read 2212 times)

0 Members and 1 Guest are viewing this topic.

Offline JZ Bowmannz

  • Posts: 128
Sysport Drawer Shelf Template Or Dimension
« on: February 26, 2017, 07:31 PM »
Hello Everyone,

I remember seeing a drawing here for the location and relative dimension of systainer's shelf (4 cut out for systainer to sit in) in the past, but I've been seaching for a while and just could not find anything.

The shelf as seen below from member Scorpion.

259001-0

Would anyone have one that I can use, please?

Thanks. JZ

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline neilc

  • Posts: 2161
Re: Sysport Drawer Shelf Template Or Dimension
« Reply #1 on: February 26, 2017, 10:37 PM »
@Scorpion  - do you have the dimensions by chance?

Offline Vondawg

  • Posts: 168
Re: Sysport Drawer Shelf Template Or Dimension
« Reply #2 on: February 26, 2017, 10:56 PM »
Garry Martin had a nice measured out template for shelves.....can't find the post
There are no mistakes....just new designs.

Offline Z48LT1

  • Posts: 61
  • My excuse is I never expected to be caught.

Offline JZ Bowmannz

  • Posts: 128
Re: Sysport Drawer Shelf Template Or Dimension
« Reply #4 on: February 27, 2017, 07:50 AM »
Here's one answer: Reply #5 at http://festoolownersgroup.com/workshops-and-mobile-vehicle-based-shops/two-deep-systainer-drawers/

Best - Gary

Never thought about cutting them separate and rejoin them together, smart!

I will follow Richard's and Billy's lead and give a try.

Thank you everyone´╝ü

JZ

Offline GarryMartin

  • Posts: 1629
Re: Sysport Drawer Shelf Template Or Dimension
« Reply #5 on: February 27, 2017, 08:32 AM »
Here's mine...

I used a different approach - 17mm bush with 10mm cutter and a template. Knocked them out in no time at all. Used in conjunction with the SYS-AZ drawers for less frequently accessed items.


Offline JZ Bowmannz

  • Posts: 128
Re: Sysport Drawer Shelf Template Or Dimension
« Reply #6 on: February 27, 2017, 09:43 AM »
@Garry, your template validated my measurement.

I had 280mm between two feet cross and 167mm front to back. Taking out 7mm bushing off set, so they are at 273mm and 160mm. The front feet are 45mm x 38mm, so your cut out is 52mm x 45mm, and they are the Datum, the rear can run wild since they are smaller... Good simple engineering!

Thank you!
JZ