Author Topic: TS-75 Blade for Cutting into Existing Wood Floor  (Read 231019 times)

0 Members and 1 Guest are viewing this topic.

Offline jbasen

  • Posts: 738
Re: TS-75 Blade for Cutting into Existing Wood Floor
« Reply #30 on: February 03, 2018, 04:56 PM »
Thanks @Naildrivingman

Since I'm sizing the hole so I don't have to cut any of the slate tiles I really don't have a choice as to where the hole is going to be cut in the floor.  So, whether the floor is held with nails or staples isn't going to matter.  I just going to have to cut through them.  It is a good point however that if the floor is held with staples they will be easier to cut through.  I'm just not going to find out until I make the cuts and start pulling up flooring  :)

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.