Author Topic: using Domino XL 700 to cut for 500 KD connectors  (Read 305 times)

0 Members and 1 Guest are viewing this topic.

Offline A-Team

  • Posts: 5
using Domino XL 700 to cut for 500 KD connectors
« on: November 03, 2018, 10:52 AM »
I've been using a lot of the Domino KD connectors (14mm) with my 700, and they've worked out really well. I'm wondering if you could use the 700 to cut (I believe 8mm) and use the new connectors made for the 500 say in 3/4" stock?

Anyone have experience with the 500 KD connectors?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Gregor

  • Posts: 1019
Re: using Domino XL 700 to cut for 500 KD connectors
« Reply #1 on: November 07, 2018, 02:10 AM »
The 700 XL works without problems for the 8mm connectors, you just need a shim (double-sided taped to the fence, as the minimum fence height on the XL is 10mm) for material thinner than 20mm to locate the mortices in the middle of the stock.