Author Topic: What’s the largest bit you’ve used in an OF 1400?  (Read 564 times)

0 Members and 1 Guest are viewing this topic.

Offline smyrnaboy93

  • Posts: 9
What’s the largest bit you’ve used in an OF 1400?
« on: October 09, 2018, 11:57 PM »
Hey Guys and Gals,

I have to flatten my first live edge slab soon for a desk.  I have small shop so unfortunately I don’t have a large enough jointer so I’m going to make a router sled to flatten it out.  I have a few routers in the 2hp -ish range but nothing larger.  I think my OF 1400 is going to get the ball on this one. 

I was just wondering what the largest planer bit anyone has used with it.  I’ve used up to 1” to make dados with no problems.  I know Infinity Tools has a 2” bit for live edges.   I’m just not sure how much plowing the ole 1400 can take.

Anyone have any experience?
« Last Edit: October 10, 2018, 12:16 AM by smyrnaboy93 »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline GarryMartin

  • Posts: 1671
Re: What’s the largest bit you’ve used in an OF 1400?
« Reply #1 on: October 10, 2018, 05:46 AM »
The maximum cutter diameter for the OF 1400 is listed at 63mm. At that size, the maximum safe speed would be 17615 rpm which equates to approximately speed 4.

For reference, the OF 1010 is 50mm and the OF 2200 is 89mm.

Obviously you need to take into account different bits of various types when considering size along with how much material you are looking to remove in each pass. Plenty of people use the OF 1400 for flattening slabs though, so it's certainly doable.

Offline smyrnaboy93

  • Posts: 9
Re: What’s the largest bit you’ve used in an OF 1400?
« Reply #2 on: October 10, 2018, 12:23 PM »
Thanks, Mate!