Woodworking & Power Tools Forum - Festool Owners Group > FESTOOL DISCUSSIONS > Festool How To... > Where do I find...
Pages: [1]   Go Down
« previous next »
  Print  
Author Topic: Where do I find...  (Read 1111 times)
0 Members and 1 Guest are viewing this topic.
WarnerConstCo.

Offline Offline

Location: Auburn, In usa
Member Since: Apr 2008
Posts: 3108



WWW
« on: July 18, 2010, 01:57 PM »
The info on tuning my ts-55.

I looked at the one supplemental manual and couldn't find anything about setting the toe in on the saw.

I started getting some ugly cuts with all 3 of my blades on friday.  All 3 blades are fairly fresh and clean so that is not the issue.

I have never had the saw leave burn marks in 3/4" poplar before, it was almost a really pathetic cut.

 
Logged
Warner Remodeling

Facebook
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Corwin

Offline Offline

Location: Washington State, USA
Member Since: Jan 2007
Posts: 1991
« Reply #1 on: July 18, 2010, 02:34 PM »
At the bottom of page 12 under the heading, "Matching the TS 55 to an Existing Guide Rail". 
Logged
Shirt Size:  L
WarnerConstCo.

Offline Offline

Location: Auburn, In usa
Member Since: Apr 2008
Posts: 3108



WWW
« Reply #2 on: July 18, 2010, 02:41 PM »
Quote from: Corwin on July 18, 2010, 02:34 PM
At the bottom of page 12 under the heading, "Matching the TS 55 to an Existing Guide Rail". 

I went back and re-read that part, I kind of skipped over it because I only have the 55 and nothing else.

I am going to have to go through the whole saw and give her a tune up. 

I don't remember pounding a nail in with it but, maybe. Big Grin
Logged
Warner Remodeling

Facebook
Pages: [1]   Go Up
  Print  
« previous next »
 
Jump to: