Author Topic: 20 mm drawer pull fits MFT.  (Read 3251 times)

0 Members and 1 Guest are viewing this topic.

Offline docterry

  • Posts: 1
20 mm drawer pull fits MFT.
« on: January 28, 2017, 11:14 AM »
I ordered several of these 20mm cylindrical drawer pulls from build.com for a few bucks each. They are a friction fit in my MFT/3 and my MFT 1080. They don't seem sturdy enough to clamp against, put they are perfect for locating a jig on the mft top.

Liberty Hardware PN2814C-C Whistle 13/16 Inch Diameter Cylindrical Cabinet Knob   


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Dick Mahany

  • Posts: 396
Re: 20 mm drawer pull fits MFT.
« Reply #1 on: January 28, 2017, 12:09 PM »
Thanks for posting that info !   I just made an MFT cart that has a removable / replicated MFT surface below the folded MFT.  I need a simple way to register that auxilliary top to the cart to prevent it from sliding around.  I think a couple of these will do the trick nicely.

« Last Edit: January 28, 2017, 02:17 PM by Dick Mahany »

Offline kitui

  • Posts: 39
Re: 20 mm drawer pull fits MFT.
« Reply #2 on: April 14, 2018, 06:14 PM »
I bought 6 of them but they are not straight. They fit quite snuggly but would not keep to holes aligned on top of each other. I love the way they fit snuggly but they are not cut straight.

Offline Gregor

  • Posts: 1065
Re: 20 mm drawer pull fits MFT.
« Reply #3 on: April 15, 2018, 03:38 AM »
I need a simple way to register that auxilliary top to the cart to prevent it from sliding around.
Some screws would do that trick, in case you are unsettled about cutting into them accidently you could also use some dominos (or simple dovels) to align it to the cart.