Author Topic: Drawing file for Conturo-AP Table DXF or PDF?  (Read 805 times)

0 Members and 1 Guest are viewing this topic.

Offline rtfosmoe

  • Posts: 6
Drawing file for Conturo-AP Table DXF or PDF?
« on: October 20, 2017, 02:48 PM »

I was wondering if anyone has created a Conturo-AP MDF Tabletop drawing?  I just recently purchased a Conturo and would like swap out my normal Multifunction tabletop when I need to do edgebanding.   I have access to a CNC which I can create the table top. Additionally, I have found the discussion on FOG and files associated with the Multifunction table top. Any assistance would be greatly appreciated.



Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.