Author Topic: Porter Cable edge guide modifed to fit Festool routers  (Read 1653 times)

0 Members and 1 Guest are viewing this topic.

Offline chazmclean

  • Posts: 1
Porter Cable edge guide modifed to fit Festool routers
« on: March 16, 2017, 04:40 PM »
This may have already been covered somewhere else, but here goes.  I modified a Porter Cable edge guide to fit the OF 1400 and the OF 1010.  The guide rods that come with the Porter Cable actually fit in the slots in both routers very snugly.  I used a piece of 3/4" x 3/8" cold rolled flatbar about 6 inches long.  I match drilled the holes to mount the bar to the guide body. These are #10-24 through holes (I used a 13/64" drill bit). Then the holes to mount the guide bars are 79mm center-to-center for the OF 1400 and 107mm center-to-center for the OF 1010, 1/4"-20 tapped holes.  I can create a drawing if anyone is interested.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.