Author Topic: Domigauges  (Read 4374 times)

0 Members and 1 Guest are viewing this topic.

Offline Terry Fogarty

  • Posts: 393
Domigauges
« on: April 25, 2007, 11:25 AM »
Because i dislike the positioning of the sprung loaded pins as they are to far from the mortice plunge for what i like to make, i got sick of continualy setting up my marking gauges to mark the plunging possition. So it occured to me why not make some Domigauges  ;D

As i pointed out in a previous post i make my own tenons, so i kept some stock  then for the faces on a separate 30mm x 60mm thick piece, plunged some 28mm deep mortices and then thicknessed of the remaining 2mm for a nice clean mortice.

The pic below shows some examples of what i use them for.

Top left is a standard marking gauge.
 
Top is one of 2 adjustable stops on a leg tapering jig.
 
Bottom right is a 2 sided gauge i use to mark offset mortices on a curved back chair rails.

Bottom mid is to mark the top of the back chair leg (the same as i posted on Dominoing a back chair leg in another thread) 

And Bottom left is the one i use most often, one side marks 20mm and the other marks 25mm. Its a very handy little gauge perfect for smaller items like chair leg/rails etc.

I dont bother putting pins, scribes or pencils in as i prefer to use the flat square end to run a light pencil mark off.


Simple and probably a bit boring for some  ;D But its just another great simple thing the Domi can do   ;)
.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Dan Clark

  • Posts: 545
    • talkFestool
Re: Domigauges
« Reply #1 on: April 25, 2007, 07:16 PM »
Creativity is NEVER boring.  Nice work!

Regards,

Dan.

Offline Brent b

  • Posts: 89
Re: Domigauges
« Reply #2 on: April 25, 2007, 07:44 PM »
I think festool needs to employ the likes of yourself, not that they have any dearth of talent, but your thinking so far outside the box that the box disappeared.
Thanks
i bought in
it's paid off
i'm going home