Author Topic: DRC 18/4 (and PDC) Belt Clip Fix  (Read 994 times)

0 Members and 1 Guest are viewing this topic.

DRC 18/4 (and PDC) Belt Clip Fix
« on: July 05, 2018, 04:26 AM »
I have a DRC 18/4 that hasn't seen as much use as I would have liked - though I prefer it to the T18 despite the extra bulk. One of the reasons is the poor belt clip which is prone to slippage walking up stairs, taking a large step or up/down a ladder. Dropping the DRC with a holesaw attached can put a dent not only in your confidence of the belt clip, but also in your clients very expensive wooden floor that YOU just put in. ;)

I was out on a new studio build and though I'd bring the DRC, took a good look at the stupid belt clip rods and then decided I would just pry them off  [eek].

Well off it was just a matter of borrowing the belt clip from the T18 (and remove the fixed 4mm screw) thread a longer 4mm insex bolt through the machine and hook it up to a cabinet connector screw on the other side. Openings on the machine wedges the T18 clip securely on the one side and the connector screw rim wedges in nice and tight on the other. A ten minute fix.

Though the clip is not centered on the machine side as on the T18 the clip works great and gravity pulls it down on a slight diagonal and keeps it firmly in place. Should have done this years ago!







I love the light on the DRC/PDC and love the grip. Will do some interior framing on six units and this will be the go to drill for that now.

Next up is the BHC 18 which is in for a similar permanent fix. EDIT: Done, posted in own thread.
« Last Edit: July 05, 2018, 05:31 PM by Henrik R / Pingvinlakrits »
Festool:  CS 50EB precisio set, Domino DF500, DF XL 700, OFK500 edge router, OF1010 router EHL65 planer, CTL Mini/Midi Vac, CTL 26 vac MFT800+1080 tables
DSC-AG Grinder,  RAS 115
Rotex 150, ETS EC 150/5 RTS400
Drills: T18, BHC18, CXS.
SysLite KAL II, SYS Rock.
Sys- and Sortainers galore.

Line up has been reduced with the introduction of Mafell/Metabo tools. Red Green and Blue do mix well in the shop.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.