Author Topic: Edge banding seamless translation  (Read 2462 times)

0 Members and 1 Guest are viewing this topic.

Offline webpp

  • Posts: 39
Edge banding seamless translation
« on: December 27, 2016, 01:59 AM »
Hi guys,

I need you guys to help me figure out how to get a seamless translation when edge banding veneer meet at a 90 degree corner.

Here is an example.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Deansocial

  • Posts: 2114
Re: Edge banding seamless translation
« Reply #1 on: December 27, 2016, 04:38 AM »
That's not veneer it's Pvc or abs edging

Offline webpp

  • Posts: 39
Re: Edge banding seamless translation
« Reply #2 on: December 27, 2016, 12:34 PM »
That's not veneer it's Pvc or abs edging

That's right. Sorry I meant PVC or ABS.

Offline webpp

  • Posts: 39
Re: Edge banding seamless translation
« Reply #3 on: January 09, 2017, 12:13 AM »
I found the answer to my question.

At 9 minute 38 second, he talks about seamless translation between two edge banding. Very nice.