Author Topic: Festool BHC 18 Belt Clip Fix  (Read 648 times)

0 Members and 1 Guest are viewing this topic.

Festool BHC 18 Belt Clip Fix
« on: July 05, 2018, 12:41 PM »
As with the DRC in the previous thread I did a number on the BHC to fit a standard Festool C18/T18 belt clip:







Very secure and way better than the slippery plastic belt rods supplied with the machine. The angle of the belt clip balances out nicely with drill and battery fitted.
Festool:  CS 50EB precisio set, Domino DF500, DF XL 700, OFK500 edge router, OF1010 router EHL65 planer, CTL Mini/Midi Vac, CTL 26 vac MFT800+1080 tables
DSC-AG Grinder,  RAS 115
Rotex 150, ETS EC 150/5 RTS400
Drills: T18, BHC18, CXS.
SysLite KAL II, SYS Rock.
Sys- and Sortainers galore.

Line up has been reduced with the introduction of Mafell/Metabo tools. Red Green and Blue do mix well in the shop.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Re: Festool BHC 18 Belt Clip Fix
« Reply #1 on: July 05, 2018, 12:42 PM »
The other way to do it is to use the Big Lugg and replace the upper screw on the BHC 18 to enable fitting of the Big Lugg.







Festool:  CS 50EB precisio set, Domino DF500, DF XL 700, OFK500 edge router, OF1010 router EHL65 planer, CTL Mini/Midi Vac, CTL 26 vac MFT800+1080 tables
DSC-AG Grinder,  RAS 115
Rotex 150, ETS EC 150/5 RTS400
Drills: T18, BHC18, CXS.
SysLite KAL II, SYS Rock.
Sys- and Sortainers galore.

Line up has been reduced with the introduction of Mafell/Metabo tools. Red Green and Blue do mix well in the shop.