Author Topic: Festool MFT3 Extensions using AIGNER table extensions  (Read 1948 times)

0 Members and 1 Guest are viewing this topic.

Offline grayedout

  • Posts: 36
Festool MFT3 Extensions using AIGNER table extensions
« on: July 17, 2017, 04:23 PM »
I have made some simple brackets which lets you use AIGNER table extensions which are light weight and not the expensive ..



how I made it ..

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Atonwa

  • Posts: 44
Re: Festool MFT3 Extensions using AIGNER table extensions
« Reply #1 on: July 17, 2017, 04:33 PM »
Brilliant, trying to figure out an extension option for mine right now. Wish those extensions were available in the US.

Offline RobBob

  • Posts: 1183
Re: Festool MFT3 Extensions using AIGNER table extensions
« Reply #2 on: July 17, 2017, 06:41 PM »
Brilliant, trying to figure out an extension option for mine right now. Wish those extensions were available in the US.

I have the same bandsaw on order.  Should be delivered in October.

@Atonwa They are available in the USA.

Aigner Table Extensions

Aigner
« Last Edit: July 17, 2017, 06:50 PM by RobBob »

Offline TinyShop

  • Posts: 36
Re: Festool MFT3 Extensions using AIGNER table extensions
« Reply #3 on: July 17, 2017, 09:15 PM »
Brilliant, trying to figure out an extension option for mine right now. Wish those extensions were available in the US.

Actually, they are available in the U.S. - though at close to twice the price as in the U.K.:

https://www.simantechinc.com/index.php?l=product_detail&p=34