Thanks Bryan,
One last question if I may! If the LS sits in the last row of holes and is about 33" from the blade, wouldn't the LS32 be a slightly better choice over the LS25? I have two MFT3s connected lengthways, so an LS32 at full extension will just hang over the second MFT, and not really be in the way. That way I could zero the LS and pull it straight back without any additional calculations - quite handy for things like standard 732mm (28 and 13/16 inch) cabinet heights...?
I keep thinking that there must be a reason why the 17 or 25 make more sense, but maybe not?
Thanks again!
Alan
Hey Alan,
I always have time for questions! I did this dance before with the 32 v 25 and picked the 25 due to the fact it covered 95% of what I could foreseeably see doing with my setup. I had planned on using my track saw to do the cabinet box cutting if the height was too tall for my single MFT setup. I also have thought about buying another MFT. I have also planned on building my own as well, just haven’t had a pressing need to do so up to this point.
I also have looked at Felder sliders over the years so as you can tell, I am all over the place!
I will generally keep my Incra in the holes fairly close to the size project I am doing (usually around the middle of the table), but can move it in under 1 minute if I need a longer or shorter distance.
One other note... I do use the router and table saw aspects of the fence quite often and the only on you need to “calibrate” is the fence to saw measurement. The router can be out of skew without messing things up, but a blade needs to be parallel to the fence or slightly toe’d in.
Cheers. Bryan.
Sent from my iPhone using Tapatalk