Author Topic: MFT Rail support scale  (Read 2093 times)

0 Members and 1 Guest are viewing this topic.

Offline A513055

  • Posts: 1
MFT Rail support scale
« on: February 11, 2017, 04:39 AM »
Hi,
There are millimetre markings embossed on the plastic of the guide rail supports of the MFT3, but there doesn't appear to be a reference line on the sliding steel portion. Are these markings supposed to represent stock thickness, suggested depth of cut or something else? What do they reference as a pointer?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Biffsbench

  • Posts: 19
Re: MFT Rail support scale
« Reply #1 on: March 08, 2017, 02:36 PM »
I just got a MFT/3 and have the exact same question.
One step closer to world domination!

Offline copcarcollector

  • Posts: 1300
Re: MFT Rail support scale
« Reply #2 on: March 08, 2017, 02:52 PM »
If i recall from end user training, those are one of those 'ignore those' things! Maybe a hold over from a different system or product, in the current offering I dont think you use them for anything---


Offline Peter_C

  • Posts: 400
Re: MFT Rail support scale
« Reply #3 on: March 08, 2017, 03:39 PM »
I do not own an MFT so...Couldn't you drop it down so the rail is resting on the table, then make a mark at ZERO with a permanent marker, from which you could now utilize those scales for height settings?