Author Topic: New Domino XL Thickness adapter project  (Read 19389 times)

0 Members and 1 Guest are viewing this topic.

Offline thlambermont

  • Posts: 2
Re: New Domino XL Thickness adapter project
« Reply #30 on: July 27, 2017, 12:09 PM »
Hello everybody,

I'm new on the forum ! I'm looking for a way to use my domino XL nn finer thicknesses and I really like your prototype.
I made a fast prototype to change "clips". What do you think about it? I use the same process design as the LA-DF 500/700.

Here for exemple I used a wooden piece of 12mm. This way I can center the domino on a 16mm mdf board.

266192-0

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline thlambermont

  • Posts: 2
Re: New Domino XL Thickness adapter project
« Reply #31 on: July 28, 2017, 03:26 AM »
It should be improved (a lot) but you can see what I had got in mind. We could imagine to put two tracks below with some screw holes (like LA-DF 500/700) and use it on smaller pieces. I'm going to look for a 3d printer near me and test it.