Author Topic: OF1400 Router Base DWG or DXF  (Read 3754 times)

0 Members and 1 Guest are viewing this topic.

Offline capww8

  • Posts: 12
OF1400 Router Base DWG or DXF
« on: October 06, 2016, 02:47 PM »
Anyone have a CAD block showing the screw positions and shape of an OF1400 router base?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline andygiddings

  • Posts: 22
Re: OF1400 Router Base DWG or DXF
« Reply #1 on: June 01, 2017, 09:00 AM »
Resurrecting this old thread as I've just created a PDF showing the router base viewed from below. Unfortunately I can't add a DWG or DXF as the file type is not allowed.

The small circle in the middle is obviously not part of the base - I used this for drilling holes in a circle template and the small circle is for centering purposes.

Offline ben_r_

  • Posts: 710
Re: OF1400 Router Base DWG or DXF
« Reply #2 on: June 01, 2017, 05:50 PM »
Resurrecting this old thread as I've just created a PDF showing the router base viewed from below. Unfortunately I can't add a DWG or DXF as the file type is not allowed.

The small circle in the middle is obviously not part of the base - I used this for drilling holes in a circle template and the small circle is for centering purposes.
How did you take the measurements? And probably should have included the outer measurements too, just for completeness :)
If at first you don't succeed, redefine success!

Offline andygiddings

  • Posts: 22
Re: OF1400 Router Base DWG or DXF
« Reply #3 on: June 05, 2017, 05:50 PM »
Digital calipers, Ben. If you print the PDF at 1:1 or full size you can use the print as a template (print on paper, card or film and then use tape to fix it to whatever you are machining)