Author Topic: Precisio CS50 + MFT  (Read 2588 times)

0 Members and 1 Guest are viewing this topic.

Offline wpz

  • Posts: 15
Precisio CS50 + MFT
« on: April 27, 2018, 06:20 PM »
Made a small MFT table today that can connect to my Precisio CS50 or CMS router table.
I can also connect it as an outfeed table if necessary (although I then lose the functionality of the sliding table).
278858-0
278860-1
278862-2
278864-3
278866-4
278868-5
278870-6
278872-7
278874-8


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline jobsworth

  • Posts: 5293
  • Does Anyone Know What Time It Is?
Re: Precisio CS50 + MFT
« Reply #1 on: April 27, 2018, 08:55 PM »
very nice, im gonna have to chase down some of that v channel so i can make something similar.

Offline rst

  • Posts: 2043
Re: Precisio CS50 + MFT
« Reply #2 on: April 28, 2018, 09:23 AM »
Jobsworth, Toolnut/Festoolproducts carry the long MFT rails.  I've bought a couple.  I cut one in half and used the two sections to join two MFT VL router tables back to back so I could put a short section with slots between to fit a Woodpeckers  MICADJ Microadjust for  moving my Festool fences.

Offline jobsworth

  • Posts: 5293
  • Does Anyone Know What Time It Is?
Re: Precisio CS50 + MFT
« Reply #3 on: April 28, 2018, 01:10 PM »
@rst

Thank you for the info. When I get time Im gonna build some things.

Offline wpz

  • Posts: 15
Re: Precisio CS50 + MFT
« Reply #4 on: April 28, 2018, 05:43 PM »
It's article number 496824 and called MFT/3-TP 2000 LA profile.
The other part I used is the VB-CMS/CS 50
278932-0