Author Topic: Ron Paulk relief cut out template set up for MFT systems  (Read 1570 times)

0 Members and 1 Guest are viewing this topic.

Offline Mgildersleeve

  • Retailer
  • *
  • Posts: 27
Ron Paulk relief cut out template set up for MFT systems
« on: January 12, 2018, 08:21 PM »


Here’s a video of a jig setup to make the cut outs for Ron Pailk’s table top system. This seems like a staple item for MFT systems, as it allows a user to reach in and clamp down threaded bench dogs. A necessity for using a hole system.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Scorpion

  • Posts: 572
Re: Ron Paulk relief cut out template set up for MFT systems
« Reply #1 on: January 13, 2018, 09:36 PM »
That’s cool.  Thanks for sharing.


Sent from my iPhone using Tapatalk Pro

Offline pettyconstruction

  • Posts: 449
Re: Ron Paulk relief cut out template set up for MFT systems
« Reply #2 on: January 13, 2018, 10:26 PM »
That’s a cool jig. I have recently been building my own paulk total station and had some less than desirable results on my template routing
My question to you though is why not reverse that and make the template the size of the hole then you don’t have to keep moving it? Or is that template built for a different application
Thanks Charlie


Sent from my iPhone using Tapatalk Pro

Offline bkharman

  • Posts: 1983
Re: Ron Paulk relief cut out template set up for MFT systems
« Reply #3 on: January 13, 2018, 11:46 PM »
That’s a cool jig. I have recently been building my own paulk total station and had some less than desirable results on my template routing
My question to you though is why not reverse that and make the template the size of the hole then you don’t have to keep moving it? Or is that template built for a different application
Thanks Charlie


Sent from my iPhone using Tapatalk Pro

This allows for all sorts of sized “ovals”. They can be the size of the template or much larger if needed. I like it, but not the clamping setup.

Cheers. Bryan.


Sent from my iPhone using Tapatalk
People, I just want to say, you know, can we all get along? Can we get along?