Author Topic: Simple corner radius jigs  (Read 23400 times)

0 Members and 1 Guest are viewing this topic.

Offline tallgrass

  • Posts: 744
Re: Simple corner radius jigs
« Reply #30 on: August 12, 2018, 04:32 PM »
I hope you enjoy it, even if it is for maintenance purposes.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline lunchman

  • Posts: 123
Re: Simple corner radius jigs
« Reply #31 on: August 28, 2018, 06:11 AM »
The original version of the Woodpeckers OTT is back,  got the email from WP this morning.  This is the 6 jig version with two radii per jig. I missed this when it was first offered (back in 2015, I looked through old emails). Price is the same as it was then.

$39.99 per jig
All six in a WP case for $239.99
All six in a Systainer for $299.99
« Last Edit: August 28, 2018, 08:35 AM by lunchman »

Offline Mario Turcot

  • Posts: 604
Re: Simple corner radius jigs
« Reply #32 on: August 28, 2018, 08:23 AM »
I was wondering.. How do you measure radius? What's the calculation to make a 1/2" or 3/4" radius. Well if you are also wondering here a video for you.

Mario

Offline ben_r_

  • Posts: 1136
Re: Simple corner radius jigs
« Reply #33 on: August 28, 2018, 11:04 AM »
The original version of the Woodpeckers OTT is back,  got the email from WP this morning.  This is the 6 jig version with two radii per jig. I missed this when it was first offered (back in 2015, I looked through old emails). Price is the same as it was then.

$39.99 per jig
All six in a WP case for $239.99
All six in a Systainer for $299.99

And knock-off for much less here if you like: LINK and LINK
If at first you don't succeed, redefine success!

Offline Gregor

  • Posts: 1065
Re: Simple corner radius jigs
« Reply #34 on: August 31, 2018, 04:06 PM »
And knock-off for much less here if you like LINK
Thanks for the link. Pricing seems reasonable on this.