Author Topic: Supercut with Festool Vecturo plunge attachment. It works!  (Read 20631 times)

0 Members and 1 Guest are viewing this topic.

Offline Magpal

  • Posts: 70
Re: Supercut with Festool Vecturo plunge attachment. It works!
« Reply #30 on: April 09, 2017, 07:44 AM »
I am bringing this thread up again as things may have changed with the new Starlock blades. I have a couple of questions regarding the compatibility of the plunge base:

-Will the plunge base also fit for the new starlock multimaster? Has anyone tried this? How large is the gap in between the magnet and the blade?
-Does the plunge base fit without the gap on the supercut or does this also has the small gap between the base and blade?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Bob D.

  • Posts: 516
Re: Supercut with Festool Vecturo plunge attachment. It works!
« Reply #31 on: April 19, 2017, 07:35 AM »
Anyone know if this should also work with a multimaster? Not sure if they use the same housing

I'd like to know the answer to this too. I have the FMM250Q and curious if this will work for me.
-----
It's a table saw, do you know where your fingers are?

Online rst

  • Posts: 1459
Re: Supercut with Festool Vecturo plunge attachment. It works!
« Reply #32 on: April 19, 2017, 09:44 AM »
I have the Supercut and the Festool plunge attachment works perfectly unless you are using the adapter to use the regular multimaster blades.  The adapter holds the multimaster blades out further than the magnet on the plunge attachment.  The plunge attachment does not fit the regular multimasrter...the drive heads are not the same.

Offline Bob D.

  • Posts: 516
Re: Supercut with Festool Vecturo plunge attachment. It works!
« Reply #33 on: April 19, 2017, 10:03 AM »
I have the Supercut and the Festool plunge attachment works perfectly unless you are using the adapter to use the regular multimaster blades.  The adapter holds the multimaster blades out further than the magnet on the plunge attachment.  The plunge attachment does not fit the regular multimasrter...the drive heads are not the same.

Hmmm, sounds like I need to let go of my Fein and get the Vecturo if I want the capabilities of the depth stop and plunge base which are both great accessories in my view.
-----
It's a table saw, do you know where your fingers are?

Offline grobkuschelig

  • Posts: 131
Re: Supercut with Festool Vecturo plunge attachment. It works!
« Reply #34 on: April 19, 2017, 05:02 PM »
Hmmm, sounds like I need to let go of my Fein and get the Vecturo if I want the capabilities of the depth stop...

If I recall correctly, a depth-stop is available from Fein directly. But the plunge base is Festool only...  [sad]