Author Topic: Tapering Jig  (Read 3067 times)

0 Members and 1 Guest are viewing this topic.

Offline Green Koolaide

  • Posts: 113
Tapering Jig
« on: December 15, 2016, 01:50 AM »
Any Festool folks come up with a  Tapering Jig? Is there safe and accurate way to just do it using the track saw?
I'm looking to do double taper legs for a table.

Any ideas are apeciated

Sent from my SM-G935W8 using Tapatalk

"Five out of every four people have problems with fractions"

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Holmz

  • Posts: 4010
Re: Tapering Jig
« Reply #1 on: December 15, 2016, 04:55 AM »
Is your MFT square?

Offline Peter Halle

  • Global Moderator
  • *
  • Posts: 11734
Re: Tapering Jig
« Reply #2 on: December 15, 2016, 06:53 AM »
You might want to check this thread and the YouTube video for some ideas:


Offline grbmds

  • Posts: 1845
Re: Tapering Jig
« Reply #3 on: December 15, 2016, 02:56 PM »
The Microjig Microbial tapering jig is great; very accurate and flexible. However, it's a little pricey at $130 and, if you're only going to use it once I'd consider trying to make a tapering jig. I've seen plans online from the various woodworking magazines and I'm sure there are videos out there with other ideas. If you plan to repetitively use it then the Microjig gives you a lot of capability, adjustability, and allows you to duplicate the same angle at a later time if you need to remake a part or are making a second version of the same project. I love it. However, it is made for use on a table saw. Don't know if it would work with a track saw.