Author Topic: Tip for setting up parallel guides  (Read 1684 times)

0 Members and 1 Guest are viewing this topic.

Online DynaGlide

  • Posts: 225
Tip for setting up parallel guides
« on: January 26, 2018, 03:50 PM »
So I finally got around to playing with my Seneca parallel guides and I knew about using a Woodpecker rule stop to setup the guides quickly. That got me to within half a mm width on a 600mm long scrap board. Being a perfectionist I took a break and came up with this to help. Butt the guides up against each other on the rail, lock them to the rail, set the first guide as normal with the rule stop/rule. Then take a square and butt the second parallel guide stop up against the square. This removes that last bit of slop. Then unlock the second parallel guide from the rail and slide it down and lock it to the rail. Doing this gave me a dead nuts on cut the length of the cut.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Online neilc

  • Posts: 2502
Re: Tip for setting up parallel guides
« Reply #1 on: January 26, 2018, 09:42 PM »
Nice idea!  I'll use it!

Offline Capt'n 360

  • Posts: 16
Re: Tip for setting up parallel guides
« Reply #2 on: February 03, 2018, 11:27 AM »
Great idea.  Always wondered how to make this dead on accurate.  This is the solution, thanks for sharing.