Author Topic: UG extensions with CMS table saw module  (Read 1370 times)

0 Members and 1 Guest are viewing this topic.

Offline onevw

  • Posts: 47
UG extensions with CMS table saw module
« on: January 08, 2017, 10:16 AM »

Is this posable?

RICK

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Woodwork Wizard

  • Posts: 408
Re: UG extensions with CMS table saw module
« Reply #1 on: January 08, 2017, 12:33 PM »
The Kapex UG extensions can be used with the CMS.

Offline epicxt

  • Posts: 402
Re: UG extensions with CMS table saw module
« Reply #2 on: January 08, 2017, 12:41 PM »
Works great.
n = number of Festools I've got.  (n + 1) = Festools I want

Offline paulc75

  • Posts: 66
Re: UG extensions with CMS table saw module
« Reply #3 on: January 08, 2017, 02:30 PM »
Works on sliding table too, any where with the v profile will accept the UG Wings