Author Topic: New Bench Fence Dogs and Fence  (Read 1821 times)

0 Members and 1 Guest are viewing this topic.

Offline Ralph Mignano

  • Retailer
  • *
  • Posts: 27
New Bench Fence Dogs and Fence
« on: April 15, 2018, 02:36 AM »

We have just released our newest dogs, The Bench Fence Dog with or without a fence.  We made these to work with Festool, Incra and our fence and due to the slot may work with other fence but not yet tested.  Visit our store at and check them out.

Feedback is always appreciated.
TS 55 R, CTL MIDI, RAILS 1400mm, DF 500 Q, OF 1400, CMS-OF, CMS-GE GB 240V, CMS-TS55, ETS 150/5, BS 75 E, MFT/3, KS120, MFK 700 EQ, T 18+3 FL, CTL 36,PS 420 EBQ, ETS EC 150/3, RTS 400 REQ, FS5000/2, FS 1400/2-LR 32, SYSROCK BR10, VAC SYS Set SE1, SYS3-Set SURFIX, FS-PA, FS-PA-VL, LR 32-SYS

Offline Roachmill

  • Posts: 82
Re: New Bench Fence Dogs and Fence
« Reply #1 on: May 14, 2018, 05:05 AM »
I picked up a pair of the fence dogs to use with the MFT fence. They hold it well in the low mode which is how I use it most often.

They also make good MFS "clamps" for want of a better word. I swapped out the M6 knobs that came with the fence dogs and used a couple of M4 ones paired with the fancy "slot nuts" that came with the MFS. A picture speaks a thousand words: