Author Topic: Tanos Attic Lid Systainer - In Stock (US)  (Read 782 times)

0 Members and 1 Guest are viewing this topic.

Offline Shane Holland

  • Festool Dealer
  • *
  • Posts: 10621
    • The Tool Nut's Festool Store
Tanos Attic Lid Systainer - In Stock (US)
« on: June 28, 2019, 05:48 PM »
I know there have been many inquiries about getting the Systainer with the attic lid over the years. For a short while, we were able to sell the Festool version until it was discontinued. We now have the Tanos SYS II with attic lid in stock, ready to ship.

Tanos Systainer II T-LOC With Attic Lid

Buy Festool Online" class="bbc_img
Fast, Free Shipping - Festool Trained Experts - Unparalleled Customer Service
Toolnut.com and FestoolProducts.com
877-866-5688

Offline RustE

  • Posts: 369
Re: Tanos Attic Lid Systainer - In Stock (US)
« Reply #1 on: June 29, 2019, 02:15 PM »
On the inside, is the attic compartment flush with the bottom edge of the lid?  Thinking this could turn into a nice router bit and accessory box.

Offline Shane Holland

  • Festool Dealer
  • *
  • Posts: 10621
    • The Tool Nut's Festool Store
Re: Tanos Attic Lid Systainer - In Stock (US)
« Reply #2 on: July 01, 2019, 09:48 AM »
On the inside, is the attic compartment flush with the bottom edge of the lid?  Thinking this could turn into a nice router bit and accessory box.

@RustE, it's about 3/16" shy of being flush. So, shorter in depth than the lid's depth. Compartment on the lid is about 7/8" deep and each of the three sections is approximately 3-1/2" x 6". Photos below.
Buy Festool Online" class="bbc_img
Fast, Free Shipping - Festool Trained Experts - Unparalleled Customer Service
Toolnut.com and FestoolProducts.com
877-866-5688

Offline rst

  • Posts: 2191
Re: Tanos Attic Lid Systainer - In Stock (US)
« Reply #3 on: July 01, 2019, 06:04 PM »
I have at least three of the attic lids that I bought from Lee Valley years ago, before Toolnut carried them.  I transferred the lids from the original syst to fit my needs.  I have one on the Syst IV that holds my Senco 1010, has air accessories in it.  Another I out one my Fein Syst to hold my blades.  An another on the Syst drawer II that holds my Milwaukee Surge and grinder.  This one holds my various counter sinks, nut drivers and extended bit holders.  The drawer holds my drill bits and accessories.

Offline RustE

  • Posts: 369
Re: Tanos Attic Lid Systainer - In Stock (US)
« Reply #4 on: July 11, 2019, 02:36 PM »
@Shane Holland , thanks for the info and apologies for the delayed response.

The template (guide bushing plate) for the OF1010 measures approximately 2-29/32 inches in diameter.  I could put a few templates in the lid with other spare parts and maybe arrange the edge guide along with some bits in the bottom.