Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: CMS miter gauge stop profile loose on swivel  (Read 749 times)

0 Members and 1 Guest are viewing this topic.

Offline jmdeacon

  • Posts: 13
CMS miter gauge stop profile loose on swivel
« on: May 11, 2018, 10:54 PM »
I am having some trouble getting the swivel on my CMS miter gauge (488451) to lock onto the stop profile with full strength.  When I twist the tightening knob on the swivel, it does tighten up the stop profile but its not very snug and with a little vibration it loosens enough that it can start to move a little.  Just to make it clear, this is the knob you can turn perpetually since it tightens and loosens every 360 degrees.  I have used my MFT swivel and when I tighten the knob, it is nice and snug.  I was able to remove and reattach the knob but it does not appear adjustable, at least as far as I can tell, so not sure how to tighten things up.

Any one else had this problem and have a solution.

Thanks
John
TS 55, OF 2200, OF 1010, Domino 500, CMS-VL, LR32, Rotex 90, Vecturo 400, CXS, T18, CT 36, CT midi

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline jmdeacon

  • Posts: 13
Re: CMS miter gauge stop profile loose on swivel
« Reply #1 on: May 13, 2018, 11:34 AM »
In case anyone has this problem in the future, I have a solution.  The problem is that the clamping plate (448071) does not pull up against the stop profile with enough force.  In my case, the gap between the small angled metal pieces that fit in the slot of the stop profile and the face of the swivel was slightly to large.  So, I gently hit those pieces with a mallet to push them down a fraction of a millimiter.  Now the stop profile is secure when I lock it only the swivel.
John
TS 55, OF 2200, OF 1010, Domino 500, CMS-VL, LR32, Rotex 90, Vecturo 400, CXS, T18, CT 36, CT midi