Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: Df500 plunge depth adjust problem.  (Read 1299 times)

0 Members and 1 Guest are viewing this topic.

Offline EdWilliams

  • Posts: 2
Df500 plunge depth adjust problem.
« on: July 06, 2017, 05:17 PM »
 I've had my DF500 about four years.  From day 1 the depth adjustment (the metal lever not the plastic clip) has been very stiff to adjust.  After my last project I gave the tool a good clean and lube.  I can now flip between all the depth settings with minimal force - EXCEPT for the 28 mm (the deepest setting), which I can't get in at all.  I'm reluctant to use more than finger strength to get it in.
  Any ideas how to fix this?  I don't want to start a random disassembly of an expensive precision tool.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Chris Wong

  • Festool Dealer
  • *
  • Posts: 866
  • I make sculptural furniture.
    • Flair Woodworks
Re: Df500 plunge depth adjust problem.
« Reply #1 on: July 08, 2017, 12:33 PM »
Interesting. I've never seen this part with any issues. I would call Festool Monday and get a recommendation from them.
Chris Wong, http://FlairWoodworks.com

The thoughts and ideas expressed here are my own and do not necessarily represent those of http://UltimateTools.ca.  But Dan does say "hello".

Offline Picktool

  • Posts: 126
Re: Df500 plunge depth adjust problem.
« Reply #2 on: July 08, 2017, 03:46 PM »
Is there something stuck in there? Wood chip?
You're talking about the 2-part knob system on the left side
below the on/off knob?

I managed a few wood pieces in there and couldnt get past 20
I took off the base and all was free moving and seen there was
crap in there. Air chucked and good to go.

Other than that, what Chris said
Well Dogey

Offline EdWilliams

  • Posts: 2
Re: Df500 plunge depth adjust problem.
« Reply #3 on: July 08, 2017, 05:31 PM »
  I does seem like it's jamming on something but I sure can't find it.  I'll call Festool.