Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: Dsc-ag 125 problem  (Read 1246 times)

0 Members and 1 Guest are viewing this topic.

Offline davidthurston

  • Posts: 1
Dsc-ag 125 problem
« on: March 12, 2018, 02:22 PM »
I purchased a dsc-ag-125  today. When it sits on the guide it is a few mm away from the splinter guard. This is on a brand new guide track.

With my ts55 the saw cuts off the splinter guard a fraction but with this tool the blafe doesnt even get close. You line up the splinter guard with your line but your final cut is a couple of mm away from the line.

Is there some adjustment I'm missing or do i have a faulty tool?

Many thanks

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Cheese

  • Posts: 5145
Re: Dsc-ag 125 problem
« Reply #1 on: March 12, 2018, 03:49 PM »
There’s an adjustment on the track saws, there may also be an adjustment on the grinder platform. Check the owners manual, it may be mentioned in there.

I’m not certain that the grinder should be touching the splinter strip. If the grinder were to dwell in one position too long, it may start to melt the splinter strip, whereas the saw would not.

Offline Alex

  • Posts: 5725
Re: Dsc-ag 125 problem
« Reply #2 on: March 12, 2018, 04:28 PM »
Here are the adjustment screws for guide clearance according to the manual. I don't know how much you can adjust them, and as Cheese said, if it is really meant to touch the splinterguard. I imagine you could easily damage your splinterguard this way.